As I posted before, I was unable to make my Linksys WRT54G router to connect to another wifi router (NETGEAR WG11) wirelessly, eventhough I downloaded a firmware that was supposed to support WDS. Yesterday, I tried again after reading an article at AnandTech: HOWTO: Use Linksys WRT54G as a Wireless Ethernet Bridge.
I downloaded all of the firmwares on www.dd-wrt.com, but only one firmware I tried, as the documentation told me to try the generic version first. After resetting my router, I saw the web menus of the router changed totally. There are more options/features available, but I was just concentrating on how to make my Linksys router could communicate and act as a bridge to my NETGEAR router as the Internet Gateway router.
I disabled all security settings, make ESSID and channels on both routers the same and then add MAC address of Linksys router in the NETGEAR's Allowed Address List. After that, I selected AP on Linksys. I checked the status, but still Linksys showed the signal is 0 dBm. After disabled security, surprisingly, after I check network status on the Linksys, it showed there was some signal. Cool, I said. But, still it did not get any IP address from NETGEAR.
I then bravely select "client-bridged", and it worked now! But I still don't know how to connect to my Linksys router, because it is now acting as a bridge and there is no IP assigned it. It is acting as a transparent bridge (connecting to NETGEAR wirelessly), and my other PC connected to the Linksys got assigned IP address from the NETGEAR.
Anyway, I am now happy because I can now used it to bridge other PCs which do not have wireless cards and the location inhibit them to connect to the Internet router by wire. I still don't know whether this wireless bridge really works as a bridge (able to connect more than one wired PCs to other PCs connected to another router) or just acts as a 'extender'. Will post again later after I've found out.
No comments:
Post a Comment